Brother GT-3 Series Service Manual page 147

6. Replacing Parts
4.
Pass the Harness with clamps and fix it with one Screw, Cord Holder 6N (2), one Screw and one Cord
Holder N5 (3).
3
<Note> Pull slightly to the right side and pass the Harness so that it will not go loose on the way.
Do not hang it down.
5.
Assemble the Reduction Belt and adjust the Tension.（See "6-1-5. Adjusting the tension of Platen Belt
and Reduction Belt".）
6.
Fix the Harness (8) with clamps shown below, and connect the Platen Motor Connector to the Main PCB
[CN4].
Clamp
(8)
Connector (CN4)
138
2
GT-3 Series
Do not go loose to the left.
Clamps