Brother GT-3 Series Service Manual page 172

Assembling
1.
Mount the Sensor Plate Support Plate (8) with the Bolt Socket (7).
2.
Connect the Connector that connects the Flap Sensor and the Flap Solenoid.
3.
Insert the right edge of the Sensor Flap Shaft (5) into the Sensor Plate Support Plate R (8) and the
Sensor Flap Dog (9), and insert the left edge into the Sensor Plate Support Plate L (6). Fix the Sensor
Plate Support Plate L (6) with the Bolt Socket (4) and fix the Sensor Flap Dog (9) with the Screw (3).
Mount the back side of the Sensor Flap Dog (9) on the Sensor Flap Release Plate (1).
Touch the convex part of the Sensor Plate Support Plate L (6) with the Frame.
4.
Mount the Cover DR. (Refer to "6-1-2. Assembling/Disassembling of the Covers".)
5.
Fix the Sensor Flap with the three screws.
6.
Mount the Cover DL and the Cover PF (refer to "6-1-2. Assembling/Disassembling of the Covers".), and
close the Front Cover UF.
GT-3 Series
6. Replacing Parts
Touch
0191Y
0190Y
163