Brother GT-3 Series Service Manual page 200

Replacement & Assembling
1.
Mount the new Cap Rubber (1) to the Cap Rubber Holder (2). Hold the both sides at the Hole of the Cap
Rubber (left photo), and make the hole slightly wider and push it to the Cap Rubber Holder.
2.
Push the Cap Rubber around the hole and make it fixed. Hook the six claws (3) around the Cap Rubber
Holder.
<Note>
Confirm that the six claws (3) are properly hooked, and push the Rubber Cap from the top to make the
Cap Rubber flat and fixed.
3.
Mount the Wiper Cleaner.
4.
Close the Front Cover UB.
5.
Turn ON the printer.
6.
Turn OFF the printer after the initial operation is confirmed.
(1)
(2)
GT-3 Series
6. Replacing Parts
(3)
(3)
191