Brother GT-3 Series Service Manual page 311

6. Replacing Parts
3.
The Needle Bracket is set as shown in the right photo; cover the top of the Cartridge Base (5), the floor
and the table with some paper or cloth (6) as shown in the left photo.
4.
Pull out all the Ink Cartridges to your side by approx. 5 cm.
5.
Remove the two Screws (7) and remove the two Clamps, NK-18N (8)
<Note>
The recent productions have neither Screws (7) nor Clamps, NK-18N (8) mounted.
6.
Remove the four Screws (9) and make the two Tube Holder Fixes (10) movable.
Keep mounting the Tubes on the Tube Holder Fixes.
(9)
(10)
302
(5)
( 6)
(7)
(7)
(8)
(8)
(9)
(10)
GT-3 Series
(6)
( 4)