Assembling
1.
Assemble the new Platen Pulse Motor (1) to the Motor Bracket (2) with the four Bolt Sockets (3).
<Note> The aspect of the Harness outlet (4) should be as shown below.
(3)
(1)
(2)
2.
Assemble the Cord Holder 5N (5) with the one Screw (6).
<Note>
- The aspect of the Cord Holder 5N should beat the angle of 45 degrees (see the left photo).
- The covering of the Harness should go to the Motor side by 10 mm (see the right photo).
(5)
(6)
3.
Assemble the Motor Bracket (2) to the Motor Connecting Plate (bottom) with the four Bolt Sockets (7).
(7)
(4)
45°
(2)
(1)
GT-3 Series
6. Replacing Parts
10 mm
Covering goes to the
Motor by 10 mm.
137