Brother GT-3 Series Service Manual page 314

11. Agitate the White Ink Cartridge (see the following instructions) and insert all the Ink Cartridges to the
Cartridge Base.
<Note>
Pigments in the White Ink are sinking little by little all the time. Hold the cartridge with both hands, upside
down from the mounted position, and shake it in 1-2 minutes so that the pigments inside can be mixed
enough. Do it one by one.
12. Mount the Cover Cartridge in the reverse step of 1 in Process 1.
13. Load the Ink into the Tubes.
Turn ON the printer. Confirm the initialization, with no errors indicated.
Load the ink by referring to "2-6-2. Introducing Ink".
14. Print Nozzle Check Pattern to confirm the print quality. (Refer to "2-6-3. Test Print".)
Process 2
1.
Remove the Cover Cartridge. Follow the operation in Process 1.
2.
Cover the top of the Cartridge Base (5), the floor and the table with some paper or cloth (6) as shown in
the left photo.
3.
Pull out the Ink Cartridges to your side that you are going to operate by approx. 5 cm.
Remove the Ink Cartridges of the both sides in the same way if the operation is not easy.
(1)
GT-3 Series
6. Replacing Parts
0054Y
305