Brother GT-3 Series Service Manual page 179

6. Replacing Parts
7.
Looking at the Print Head from below, visually check that the Crushless Plate (7) and Cap Rubber are in
the correct position. Adjust the front/rear position if there is a problem.
a) The ink mark (6) of the Cap Lips should not protrude from the Crushless Plate (7).
b) The ink mark (6) of the Cap Lips should not contact the Nozzle Plate surface (8).
8.
Connect the Connector (10) of the Maintenance PCB (9). Mount the Cord Clamp (11).
9.
Mount the Flushing Plate.
10. Mount the Covers. Refer to "6-1-2. Assembling/Disassembling of the Covers".
11. Remove the Print Head Protection Films.
12. Turn ON the printer.
13. Confirm the initialization. Turn OFF the printer.
170
Nozzle Plate (8)
(6)
(7)
OK
(9)
(10)
(6)
(10)
GT-3 Series
!
NG
(11)