Fusing Loop Size; Manual Bypass Tray Adjustment; Lead Edge Erase Adjustment; Firmware Version - Konica Minolta bizhub C250P Service Manual

17. Jig Soft
17.5.6

Fusing Loop Size

Functions • To vary the timing to start fusing loop processing and adjust the fusing loop size at
Envelope printing.
Use • To be used when paper wrinkle or transfer misalignment occur at Envelope printing.
Adjustment in +: Delay the timing to start fusing loop processing
Adjustment in -: Put ahead the timing to start fusing loop processing
Setting/ • The default setting is 0.
Procedure
17.5.7

Manual Bypass Tray Adjustment

Functions • To set the maximum width and the minimum width for the Manual Bypass Paper Size
Unit of the Manual Bypass Guide
Use • Use when the Manual Bypass Paper Size Unit of the Manual Bypass Guide has been
changed.
• Use when a false paper size is displayed when the manual Bypass is used.
Setting/ 1. Call the Service Mode to the screen.
2. Click these keys in this order: [Machine] → [Manual Bypass Tray Adjustment].
Procedure
3. Click [Max. Width].
4. Load the Bypass Tray with paper having a width of 301 mm.
5. Press the Start key and check that the results are [OK].
6. Click [Min. Width.].
7. Load the Bypass Tray with paper having a width of 89 mm.
8. Press the Start key and check that the results are [OK].
✽ Make the adjustment again if the results are [NG].
17.5.8

Lead Edge Erase Adjustment

Functions • To set the leading edge erase amount of the paper.
Use • To change the width of the area not printed along the leading edge of the paper
Setting/ • The default setting is 4 mm.
Procedure

17.6 Firmware Version

Functions • To check the Firmware version.
Use • Use when the firmware is upgraded.
• When the firmware is upgraded or PWB is replaced.
Setting/ 1. Call the Service Mode to the screen.
Procedure 2. Click [Firmware Version].
3. Select the appropriate key from 1 to 3 to check the Firmware Version.
224
"0" (-2 to +2)
"4 mm" 5 mm
Field Service Ver. 2.0 Mar. 2006
7 mm