Konica Minolta bizhub C250P Service Manual page 246

Field Service Ver. 2.0 Mar. 2006
(3) RAM Clear
Functions • To clear the following data at the Center
ID Code, Primary Setting, Date/Time Input, and Common DT.
Use • To be used for setting CS Remote Care.
• To be used for reset the every data of the Center to default.
Setting/ • Press the Menu/Select key to start RAM Clear.
Procedure
(4) Log Print
Functions • To print out the Communication Log.
Use • Use to output and use the Communication Log.
Setting/ • Press the Menu/Select key to print out the Communication Log.
1
Procedure • Load Tray 1 or Bypass Tray with A4S paper.
<Simplex/Duplex>
• The default setting is 1-Sided.
(5) Software SW
Functions • To change the CS Remote Care settings.
Use • To change the settings for CS Remote Care as necessary.
Setting/
See P.198
Procedure
(6) Response Time Out
1
Functions • It sets the intervals for resending E-Mails when transmission error occurred.
• It can be set only when [E-Mail] is selected by System Setting.
Use • To use when changing the intervals for resending E-Mails when transmission error
occurred.
Setting/ • The default setting is 60 minute.
Procedure
(7) Reset Command
Functions • To set the command to be issued at the time of Modem Initialization.
• This setting is available only when "Modem" is selected for the system setting.
Use • To set the command to be issued at the time of Modem Initialization.
Setting/ • Enter the command and Press the Menu/Select key to register.
Procedure
"60 minute" (10 to 1440)
16. TECH. REP. MODE
205