Dimm0 (Work0), Dimm1 (Work1) - Konica Minolta bizhub C250P Service Manual

11. Other
[9]
[10]
NOTE
1
• When the Firmware's card Ver. is Ver 81 or later, the following operation must be
performed without fail when replacing the MFP Control Board.
➀
Update the Firmware to the latest version.
➁
Perform the following setting for all the patterns.
[Service Mode] → [Imaging Process Adjustment] →
[X-Rite Calibration (Gradation Adjust)] of the Jig software
See P.51
➂
Perform the following setting.
[Tech. Rep. Mode] → [Data Backup] of the Control Panel
See P.194
11.3.16

DIMM0 (Work0), DIMM1 (Work1)

[1]
90
[9]
4038F2C081DA
4038F2C507DA
Field Service Ver. 2.0 Mar. 2006
8. Remove thirteen Screws [9], and
remove the MFP Control Board [10].
NOTE
• When the MFP Control Board is
replaced, mount the removed
NVRAM to the new MFP Control
Board.
• When the MFP Control Board is
replaced, make sure to update the
firmware.
1. Remove the Upper Rear Cover,
Lower Rear Cover and Rear Right
Cover.
See P.74, 76
2. Remove thirteen Screws, and
remove the Shield cover [1].