Replacing The Actuator Module - Invacare Kite Service Manual

®
Invacare - Kite
8.2.2

Replacing the actuator module

Requirements:
· 7 mm socket wrench
· Phillips screwdriver, size 2
Removing the actuator module:
·
Switch the electronics OFF on the remote.
·
Remove the rear cover, as described in chapter 8.1.1.
·
Take exact note of the positions of all cables and the sockets that they are connected to. Mark
the connectors and sockets or take a photograph with a digital camera.
·
Disconnect the plugs (3) from the actuator module (2).
·
Loosen both screws (1) with a Phillips screwdriver.
·
Replace the actuator module.
Installing the actuator module:
·
Assemble the parts in reverse order.
·
Reconnect all cable connectors to their former positions.
·
Plug all free slots with a suitable rubber stopper, see chapter 4.2.
·
The last step is to test all functions of the vehicle.
SERVICE MANUAL
35