Table of Contents
Advertisement
After reboot completes, the master LED will turn on.
2
Configure the Switch stacking priority to a high value, such as 63.
3
Change a second Switch to stacking mode and wait for it to finish rebooting automatically. This
4
master LED will also turn on.
Connect the two Switches using the stacking ports for the Switch defined.
5
The second Switch master LED will then turn off, and its Sys LED will blink while it's initializing.
6
Please wait until it stops blinking, indicating that it has joined the stack.
Repeat steps 4 to 6 to connect other Switches to the stack.
7
When the Switch is in Stacking mode, the web configurator will change port and VLAN port settings
to support the stacking mode. See
on the port settings.
Click Basic Setting > Stacking > Configuration to see the following screen.
Figure 59 Basic Setting > Stacking > Configuration
Chapter 6 Basic Setting
Section 6.6 on page 69
GS3700/XGS3700 Series User's Guide
98
and
Section 7.7 on page 106
for details
Advertisement
Table of Contents
