ZyXEL Communications xg3700 series User Manual page 432

Click IP Application, VRRP and click the Configuration link to display the VRRP Configuration
screen as shown next.
Note: You can only configure VRRP on interfaces with unique VLAN IDs.
Note: Routing domains with the same VLAN ID are not displayed in the table indicated.
Figure 321 IP Application > VRRP Configuration: IP Interface
The following table describes the labels in this screen.
Table 216 IP Application > VRRP Configuration: IP Interface
LABEL DESCRIPTION
Index This field displays the index number of an entry.
Network This field displays the IP address and number of subnet mask bit of an IP domain.
Authentication Select None to disable authentication. This is the default setting.
Select Simple to use a simple password to authenticate VRRP packet exchanges on this
interface.
Key When you select Simple in the Authentication field, enter a password key (up to eight
printable ASCII character long) in this field.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to discard all changes made in this table.
Chapter 44 VRRP
GS3700/XGS3700 Series User's Guide
432