Table of Contents
Advertisement
Figure 384 Management > Configure Clone (Stacking)
The following table describes the labels in this screen.
Table 255 Management > Configure Clone
LABEL
DESCRIPTION
Source/
In stacking mode, a port is defined by a slot ID representing the Switch in the stack and a
Destination
port number.
Port / Slot
Select the source port and slot (in stacking mode) under the Source label. This port's
(Stacking)
attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports which
are going to have the same attributes as the source port. You can enter individual ports
separated by a comma or a range of ports by using a hyphen. For example, 2, 4, 6 indicates
that ports 2, 4 and 6 are the destination ports. 2-6 indicates that ports 2 through 6 are the
destination ports.
In stacking mode, you can select multiple destination slots.
Basic Setting
Select which port settings (configured in the Basic Setting menus) should be copied to the
destination port(s).
Chapter 58 Configure Clone
GS3700/XGS3700 Series User's Guide
506
Advertisement
Table of Contents
