Table of Contents
Advertisement
Chapter 5 ZON Utility, ZON Neighbor Management and Port Status
The following table describes the fields in the above screen.
Table 6 Status
LABEL
DESCRIPTION
Device Information
Device Type
This field displays the model name of this Switch.
System Name
This field displays the name used to identify the Switch on any network.
Boot Version
This field displays the version number and date of the boot module that is currently on
the Switch.
System Location
This field displays the geographic location of your Switch. You can change the setting
in the Basic Setting > General Setup screen.
Firmware Version
This field displays the version number and date of the firmware the Switch is currently
running.
System Time
This field displays the current date and time in the UAG. The format is mm-dd-yyyy
hh:mm:ss.
Serial Number
This field displays the serial number of this Switch. The serial number is used for
device tracking and control.
System Up Time
This field displays how long the Switch has been running since it last restarted or was
turned on.
MAC Address
This field displays the MAC addresses of the Switch.
Login Timeout
This field displays how many minutes a management session can be left idle before the
session times out. After it times out you have to log in with your password again.
Stacking topology
This field displays whether the current topology is Chain or Ring.
(Stacking mode)
Detail
Click this link to go to the Basic Setting > System Info screen to check other
detailed information, such as system resource usage and the Switch temperature, fan
speeds or voltage.
IP Address Information
IPv4 Address
This field displays the Switch's current IPv4 address.
Subnet Mask
This field displays the Switch's subnet mask.
Default Gateway
This field displays the IP address of the Switch's default gateway.
IP Setup
Click the link to go to the Basic Setting > IP Setup screen.
IPV6 Global Unicast
This field displays the Switch's IPv6 global unicast address.
Address
IPV6 Link-Local
This field displays the Switch's IPv6 link-local address.
Address
IPv6 configuration
Click the link to go to the Basic Setting > IPv6 screen.
Device Status and
This section shows whether a feature is enabled or not on the Switch. You can click a
Quick Configuration
feature's Setting link to go to the configuration screen for the feature.
Hover your cursor over a red exclamation mark to display information about the
feature.
Note: The Stacking Status field is displayed only on the Switch with stacking support.
Quick Links
This section provides the shortcut link to a specific cofiguration screen.
GS3700/XGS3700 Series User's Guide
48
Advertisement
Table of Contents
