Table of Contents
Advertisement
Figure 121 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP (Stacking
mode)
The following table describes the labels in this screen.
Table 78 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL
DESCRIPTION
Link
Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Aggregation
Control
Protocol
Active
Select this checkbox to enable Link Aggregation Control Protocol (LACP).
System Priority
LACP system priority is a number between 1 and 65,535. The switch with the lowest system
priority (and lowest port number if system priority is the same) becomes the LACP "server".
The LACP "server" controls the operation of LACP setup. Enter a number to set the priority of
an active port using Link Aggregation Control Protocol (LACP). The smaller the number, the
higher the priority level.
Group ID
The field identifies the link aggregation group, that is, one logical link containing multiple
ports.
LACP Active
Select this option to enable LACP for a trunk.
Chapter 15 Link Aggregation
GS3700/XGS3700 Series User's Guide
182
Advertisement
Table of Contents
