Table of Contents
Advertisement
Figure 171 Advanced Application > Multicast > MVR > Group Configuration
The following table describes the labels in this screen.
Table 111 Advanced Application > Multicast > MVR > Group Configuration
LABEL
DESCRIPTION
Multicast VLAN
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down list
ID
box.
Group Name
Enter a descriptive name for identification purposes.
Start Address
Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Refer to
End Address
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP
address for a multicast group.
Refer to
Add
Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
MVLAN
This field displays the multicast VLAN ID.
Group Name
This field displays the descriptive name for this setting.
Start Address
This field displays the starting IP address of the multicast group.
End Address
This field displays the ending IP address of the multicast group.
Delete
To delete the profile(s) and all the accompanying rules, select the profile(s) that you want to
remove, then click the Delete button. You can select the check box in the table heading row
to select all profiles.
To delete a rule(s) from a profile, select the rule(s) that you want to remove, then click the
Delete button.
Chapter 23 Multicast
Section 23.1.1 on page 227
Section 23.1.1 on page 227
GS3700/XGS3700 Series User's Guide
249
for more information on IP multicast addresses.
for more information on IP multicast addresses.
Advertisement
Table of Contents
