Table of Contents
Advertisement
One of the LEDs does not behave as expected.
Make sure you understand the normal behavior of the LED. See
1
Check the hardware connections. See
2
Inspect your cables for damage. Contact the vendor to replace any damaged cables.
3
Turn the Switch off and on (in DC models or if the DC power supply is connected in AC/DC models).
4
Disconnect and re-connect the power adaptor or cord to the Switch (in AC models or if the AC
5
power supply is connected in AC/DC models).
If the problem continues, contact the vendor.
6
60.2 Switch Access and Login
I forgot the IP address for the Switch.
The default in-band IP address is 192.168.1.1.
1
Use the console port to log in to the Switch.
2
Use the MGMT port to log in to the Switch, the default IP address of the MGMT port is 192.168.0.1.
3
If this does not work, you have to reset the device to its factory defaults. See
4
44.
I forgot the username and/or password.
The default username is admin and the default password is 1234.
1
If this does not work, you have to reset the device to its factory defaults. See
2
44.
I cannot see or access the Login screen in the web configurator.
Make sure you are using the correct IP address.
1
• The default in-band IP address is 192.168.1.1.
Chapter 60 Troubleshooting
Section 3.1 on page
GS3700/XGS3700 Series User's Guide
511
Section 3.3 on page
30.
Section 4.6 on page
Section 4.6 on page
35.
Advertisement
Table of Contents
