Table of Contents
Advertisement
Chapter 35 Link Layer Discovery Protocol (LLDP)
Figure 261 Advanced Application > LLDP > LLDP Configuration (Stacking mode)
The following table describes the labels in this screen.
Table 174 Advanced Application > LLDP > LLDP Configuration
LABEL
DESCRIPTION
Active
Select to enable LLDP on the Switch. It is enabled by default.
Transmit Interval
Enter how many seconds the Switch waits before sending LLDP packets.
Transmit Hold
Enter the time-to-live (TTL) multiplier of LLDP frames. The device information on the
neighboring devices ages out and is discarded when its corresponding TTL expires. The
TTL value is to multiply the TTL multiplier by the LLDP packets transmitting interval.
Transmit Delay
Enter the delay (in seconds) between successive LLDPDU transmissions initiated by value
or status changes in the Switch MIB.
Reinitialize Delay
Enter the number of seconds for LLDP to wait before initializing on a port.
Apply
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Slot (Stacking
This field appears only in stacking mode. Click the drop-down list to choose the slot
mode)
number of the Switch in a stack.
Port
This displays the Switch's port number. * means all ports (on the same Switch). In
Stacking mode, the first number means Slot ID and the second is the port.
GS3700/XGS3700 Series User's Guide
360
Advertisement
Table of Contents
