Table of Contents
Advertisement
Figure 28 Basic Setting > Switch Setup
The following table describes the labels in this screen.
Table 13 Basic Setting > Switch Setup
LABEL
DESCRIPTION
VLAN Type
Choose 802.1Q or Port Based. The VLAN Setup screen changes depending on whether
(Standalone
you choose 802.1Q VLAN type or Port Based VLAN type in this screen. See
mode only)
page 101
stacking mode (Active is enabled in Basic Setting > Stacking > Configuration), so
this field does not display in stacking mode.
Bridge Control
Select Active to allow the Switch to handle bridging control protocols (STP, for example).
Protocol
You also need to define how to treat a BPDU in the Port Setup screen.
Transparency
MAC Address
MAC address learning reduces outgoing traffic broadcasts. For MAC address learning to
Learning
occur on a port, the port must be active.
Aging Time
Enter a time from 10 to 1000000 seconds. This is how long all dynamically learned MAC
addresses remain in the MAC address table before they age out (and must be relearned).
ARP Aging Time
Aging Time
Enter a time from 60 to 1000000 seconds. This is how long dynamically learned ARP
entries remain in the ARP table before they age out (and must be relearned). The setting
here applies to ARP entries which are newly added in the ARP table after you click Apply.
Switch
GARP Timer:
es join VLANs by making a declaration. A declaration is made by issuing a Join message
using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all
registrations. GARP timers set declaration timeout values. See
information.
Join Timer
Join Timer sets the duration of the Join Period timer for GVRP in milliseconds. Each port
has a Join Period timer. The allowed Join Time range is between 100 and 65535
milliseconds; the default is 200 milliseconds. See
background information.
Leave Timer
Leave Time sets the duration of the Leave Period timer for GVRP in milliseconds. Each
port has a single Leave Period timer. Leave Time must be two times larger than Join
Timer; the default is 600 milliseconds.
Leave All Timer
Leave All Timer sets the duration of the Leave All Period timer for GVRP in milliseconds.
Each port has a single Leave All Period timer. Leave All Timer must be larger than Leave
Timer.
Chapter 6 Basic Setting
for more information. The Switch does not have port-based VLAN available in
GS3700/XGS3700 Series User's Guide
64
Chapter 7 on page 101
for more background
Chapter 7 on page 101
Chapter 7 on
for more
Advertisement
Table of Contents
