Table of Contents
Advertisement
Chapter 5 ZON Utility, ZON Neighbor Management and Port Status
Status > Neighbor
Figure 20
The following table describes the fields in the above screen.
Table 7 Status > Neighbor
LABEL
DESCRIPTION
Local
Port
This shows the port of the Switch, on which the neighboring device is discovered.
Desc.
This shows the port description of the Switch.
PoE Draw
This shows the consumption that the neighboring device connected to this port draws
from the Switch. This allows you to plan and use within the power budget of the
Switch.
Remote
Port
This show the number of the neighbor device's port which is connected to the Switch.
Desc.
This shows the description of the neighbor device's port which is connected to the
Switch.
Model
This shows the model name of the neighbor device. This field will show "-" for non-
ZyXEL devices.
System Name
This shows the system name of the neighbor device.
Location
This shows the geographic location of the neighbor device.
Firmware
This shows the firmware version of the neighbor device. This field will show "-" for
non-ZyXEL devices.
IP
This shows the IP address of the neighbor device. The IP address is a hyper link that
you can click to log into and manage the neighbor device through its web configurator.
This field will show "-" for non-ZyXEL devices.
MAC
This shows the MAC address of the neighbor device. This field will show "-" for non-
ZyXEL devices.
PWR Cycle
Click the Cycle button to turn OFF the power of the neighbor device and turn it back
ON again. A count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
Note: If multiple neighbor devices use the same port, the Cycle button is displayed only
Reset to Default
Click the Reset button to reset the neighbor device to its factory default settings. A
warning message "Are you sure you want to load factory default?" appears
prompting you to confirm the action. After confirming the action a count down button
(from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
Note: If multiple neighbor devices use the same port, the Reset button is not available
Note: You can only reset ZyXEL products.
powered device (PD).
on the first device, others will show "-" instead.
powered device (PD).
and will show "-" instead.
GS3700/XGS3700 Series User's Guide
50
Advertisement
Table of Contents
