Table of Contents
Advertisement
Figure 32 Basic Setting > IP Setup > IP Configuration
The following table describes the labels in this screen.
Table 17 Basic Setting > IP Setup > IP Configuration
LABEL
DESCRIPTION
Default Gateway Type the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254.
Default
Specify which traffic flow (In-Band or Out-of-band) the Switch is to send packets
Management
originating from itself (such as SNMP traps) or packets with unknown source.
Select Out-of-band to have the Switch send the packets to the management port labelled
MGMT. This means that device(s) connected to the other port(s) do not receive these
packets.
Select In-Band to have the Switch send the packets to all ports except the management
port (labelled MGMT) to which connected device(s) do not receive these packets.
Apply
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to reset the fields to your previous configuration.
Out-of-band Management IP Address
Use these fields to set the settings for the out-of-band management port.
IP Address
Enter the out-of-band management IP address of your Switch in dotted decimal notation.
For example, 192.168.0.1.
IP Subnet
Enter the IP subnet mask of your Switch in dotted decimal notation, for example,
Mask
255.255.255.0.
Chapter 6 Basic Setting
GS3700/XGS3700 Series User's Guide
68
Advertisement
Table of Contents
