Ricoh D117 Service Manual page 330

Firmware Update
3. Insert the SD card into SD Card Slot 2 (lower). Make sure the label on the SD card faces the
rear side of the machine.
4. Slowly push the SD card into the slot so it locks in place. You will hear it click. Make sure the
SD card locks in place.
To remove the SD, push it in to unlock the spring lock. Then release it so it pops out
of the slot.
5. Disconnect the network cable from the copier if the machine is connected to a network.
6. Switch the main power switch on. After about 45 seconds, the initial version update screen
appears on the LCD in English.
7. On the screen, touch the button or press the corresponding number key on the operation
panel to select the item in the menu that you want to update.
ROM/NEW
ROM:
NEW:
Controller, engine and operation panel firmware cannot be updated at the same time.
It is recommended to update firmware modules one by one.
8. Touch "UpDate (#)" (or
D117/D118
Tells you the number of the module and name of the version
currently installed. The first line is the module number, the second
line the version name.
Tells you the number of the module and name version on the SD
card. The first line is the module number, the second line the
version name.
) to start the update.
What it means
5-20 SM