Place A Test Call; Set Neon Voltage - Ring Ping - Avaya CMC1 Installation, Upgrades And Additions

Completing Installation and Cable Pinouts

Place a Test Call

To place a test call:
1. From any telephone connected to a digital line circuit pack, call any nearby telephone
connected to an analog line circuit pack.
2. Verify that the dial tone, ringing pattern, and talk path are acceptable.
3. Place a call through the Central Office (outside call) to any nearby telephone. Verify that the
dial tone, ringing pattern, and talk path are acceptable.
Set Neon Voltage — Ring Ping
Note:
If the ringing option is set to 50 Hz, neon voltage is not available. If 25 Hz is
Note:
selected, the maximum voltage is 120 volts. Refer to
page 76.
Note:
Set the control to OFF if there are no neon message waiting lamps or if LED
Note:
message lamps are used. See
Figure 68: Setting the Neon Voltage
156 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
Figure 68.
didmt1 KLC 053097
Set Ringing Option on