Testing The Switch-To-Adjunct Link - Avaya CMC1 Installation, Upgrades And Additions

change system-parameters cdr
Node Number (Local PBX ID):
Primary Output Format: unformatted
Secondary Output Format: unformatted Secondary Output Endpoint: CDR2
Use Enhanced Formats? n
Modified Circuit ID Display? n
Suppress CDR for Ineffective Call Attempts? y
Disconnect Information in Place of FRL? n
Force Entry of Acct Code for Calls Marked on Toll Analysis Form? n
Record Called Vector Directory Number Instead of Group or Member? n
Inc Trk Call Splitting? n
Record Non-Call-Assoc TSC? n
Record Call-Assoc TSC? n
Privacy - Digits to Hide: 0
2. In the Primary Output Format field, enter a format specific to the call accounting system, if
necessary. In the example, unformatted is used. If you were sending data directly to a
printer, you would use printer.
3. In the Primary Output Endpoint field, type CDR1.
4. If you use a secondary output device, and that device is also connected through TCP/IP,
complete the Secondary Output Format field. Also, type CDR2 in the Secondary Output
Endpoint field.
5. Press ENTER to save your changes.

Testing the switch-to-adjunct link

You can use the test, status, busyout and release commands to find and correct problems with
CDR links. For more information about these commands, see the Maintenance manual for your
switch.
status cdr-link
Link State: up
Maintenance Busy? no
CDR SYSTEM PARAMETERS
Use ISDN Layouts? n
Record Outgoing Calls Only? y
Record Called Agent Login ID Instead of Group or Member? n
Primary
Primary Output Endpoint: CDR1
Condition Code 'T' for Redirected Calls? n
Remove # From Called Number? n
Calls to Hunt Group - Record: member-ext
Digits to Record for Outgoing Calls: dialed
CDR Account Code Length: 4
CDR LINK STATUS
Secondary
extension not administered
Install Call detail recording (CDR)
Page
CDR Date Format: month/day
EIA Device Bit Rate: 9600
Intra-switch CDR? n
CDR Call Splitting? y
Attendant Call Recording? y
Interworking Feat-flag? n
Issue 10 June 2005
1 of 1
313