Ricoh SP 5200S Operating Instructions Manual page 34

1. Preparing the Machine
If the "Device driver software was not successfully installed" message appears, close the message,
and then proceed to step 5.
5. On the [Start] menu, click [Devices and Printers].
6. Click [Add a printer].
7. Click [Add a local printer].
8. Check the [Use an existing port:] check box, and select WSD port.
9. Click [Next].
10. Click [Have Disk...].
11. Insert the CD-ROM into the CD-ROM drive.
If the [AutoPlay] dialog box appears, click the [Close] button.
12. Click [Browse...], and then specify a location for the printer driver.
If the CD-ROM drive is D, the source files of the printer driver are stored in the following locations:
• PCL 5e
D:\x86 or X64\DRIVERS\PCL5e\XP_VISTA or X64\(Language)\DISK1
• PCL 6
D:\x86 or X64\DRIVERS\PCL6\XP_VISTA or X64\MUI\DISK1
• PostScript 3
D:\x86 or X64\DRIVERS\PS\XP_VISTA or X64\MUI\DISK1
The PCL 6 printer driver is installed in the language specified by your operating system.
13. Click [OK] to close the [Install From Disk] window.
14. Select the manufacturer and model name of the machine you want to use, and then click
[Next].
15. Follow the instructions on the screens.
According to your needs, you may change the machine name, configure the machine as a default
printer and/or a shared printer, and print a test page.
16. Click [Finish].
If installation is successful, the icon of the printer connected to the WSD port is added to the
[Devices and Printers] window.
• The port name that follows "WSD" uses random character strings. It cannot be changed freely.
• To stop installation of the selected driver, click [Cancel] before the installation is complete. When
re-installing the WSD Port, right-click the machine's icon in the [Network] window, and then click
[Uninstall].
32