Important Information Regarding Warranty Information; Fs One; Radio Installation - Hangar 9 Funtana 125 Assembly Manual

Important Information
Regarding Warranty Information
Please read our Warranty and Liability Limitations section on
Page 55 before building this product. If you as the purchaser
or user are not prepared to accept the liability associated
with the use of this Product, you are advised to return this
Product immediately in new and unused condition to the
place of purchase.
FS One®
With FS One (HANS2000) you get more than photorealistic
fields, gorgeous skies and realistic-looking aircraft. You get
incredibly advanced aerodynamic modeling that simulates
every possible aspect of real-world flight.
The first Hangar Pack (HANS4010) will add even more
aircraft to FS One. This latest edition includes ten new planes
and helis from your favorite brands, including Hangar 9,
E-flite and Align. You'll be able to fly aircraft that are only
available on FS One such as the T-REX, Blade CX2, Blade CP
Pro, Hangar 9 P-51 and F-22 PTS. And as always, with the
Hangar Pack, you still get all the same great features that
you did with the original aircraft.
HANS2008
6
Required Parts
Fuselage
Servo with hardware (3) (Rudder (1), Elevator (2)
Receiver
Switch harness with hardware
3-inch (76mm) servo extension (2) (ailerons)
18-inch (457mm) servo extension (rudder)
18-inch (457mm) servo extension (2) (elevator)
2mm x 12mm self-tappng screw (2)
Receiver battery (gas or glow option)
Servo with hardware (gas or glow option)
Tools and Adhesives
Drill bit: 1/16-inch (1.5mm)
Thin CA
Hook and loop strap
Foam rubber: 1/4-inch (6mm)

Step 1
Locate the items necessary to install the radio components
included with your model.
HANS4010

Radio Installation

Plywood receiver tray
Pin vise
Phillips screwdriver: #1

Step 2
Prepare the rudder and elevator servos by installing the
grommets and brass eyelets in each servo. Remove the
servo arms from the servos at this time.

Step 3
Place the rudder servo in the opening in the left side of the
fuselage with the output of the servo facing toward the rear
of the model as shown. Make sure the servo is centered in
the opening. Use a pin vise and 1/16-inch (1.5mm) drill bit
to drill the four holes for the servo mounting screws.
Hangar 9 Funtana 125 ARF Assembly Manual