Hangar 9 Funtana 125 Assembly Manual page 31


Step 2
Use four 4mm x 25mm hex head bolts and four 4mm
washers to attach the engine mount rails to the firewall.
Tighten the screws using a 3mm hex wrench after applying
threadlock to each of the screws.

Step 3
Check the position of the carburetor in relationship to the
engine. It should match the photo. If not, you will need to
rotate the carburetor following the instructions provided with
the engine. Also make sure the carburetor arm is facing to
the top of the engine.
Hangar 9 Funtana 125 ARF Assembly Manual

Step 4
Position the engine so the drive washer is 5
forward of the firewall.

Step 5
Use a pencil to transfer the locations for the engine
mounting bolts to the engine mount rails.

Step 6
/ -inch (133mm) Use a pencil to mark the location for the throttle pushrod
1
4
tube.

Step 7
Remove the engine from the mount and use a drill and a
5/32-inch (4mm) drill bit to drill the four holes for the engine
mounting bolts.
Hint: It is recommended to use a drill press to drill the
holes so they are straight in the mount.
31