Table of Contents
Advertisement
Radio Systems Requirements
Spektrum Radio System
• DX6i 6-channel radio or greater with receiver
(SPM6600)
• JRPS821 DS821 Digital Sport Servo (5)
(4 required for EP version)
• JSP98110 6-inch Servo Extension (2)
• JSP98020 Y-Harness or JSP98110 6-inch Servo
Extension (2) for receiver to aileron servos
• Receiver Battery, 2700mAh
• Deluxe Chargeswitch (JRPA004)
Optional
• JSP98020 Y-Harness or JSP98110 6-inch
Servo Extension to connect the float rudder
servo to the receiver.
Recommended Setup–2-Stroke glow
• Evolution
.46NX with Muffler (EVOE0461)
®
• Evolution Propeller 11 x 5 (EVO11050) to
11 x 6 (EVO11060)
Recommended Setup–4-Stroke glow
• Saito
™
.82 AAC w/Muffler (SAIE082AGK or SAIE082A)
• Evolution Propeller 13 x 8 (EVO13080) or
14 x 6 (EVO14060)
Recommended Setup–
Electric Power (EP)
• E-flite
Power 46 BL Outrunner Motor (EFLM4046A)
®
• 60-Amp Pro Switch-Mode BEC Brushless ESC
(EFLA1060)
• Thunder Power 4S 3850–4500mAh Li-Po Battery Pack
• APC Propeller 13x6.5-inch (APC13065E) to
14x7 (APC14070E)
Field Equipment Required
• Fuel (15% recommended)
• Propeller
• Long Reach Glow Plug Wrench (HAN2510)
• Metered Glow Driver w/Ni-Cd & Charger (HAN7101)
• 2-Cycle Sport Plug (EVOGP1)
The Spektrum trademark is used with permission
• Manual Fuel Pump (HAN118)
of Bachmann Industries, Inc.
4
optional Field Equipment
• Selfstick weights, 6 oz (HAN3626)
• PowerPro 12V Starter (HAN161)
• 12V 7Ah Sealed Battery (HAN102)
• Power Panel (HAN106)
• Blue Block After Run Oil (EVOX1000)
• Cleaner and towels
Additional Required Tools
Drill
File
Pin drill
Pliers
Ruler
Scissors
Side cutters
Flat blade screwdriver
Medium grit sandpaper
Metric propeller reamer
Hobby knife with #11 blade
Phillips screwdriver: #1, #2
Z-bend Pliers (HAN119)
Box wrench to fit propeller nut
Box end or open end wrench: 1/4-inch, 7/16-inch,
1/2-inch
Hex wrench or ball driver: 3/32-inch
Drill bit: 5/64-inch (2mm), 5/32-inch (4mm)
Additional Required Adhesives
Canopy Glue
(PAAPT56)
Medium CA
(PAAPT02)
Thin CA
(PAAPT08)
Zap-A-Dap-A-Goo
(PAAPT12)
Threadlock
(PAAPT42)
30-Minute Epoxy
(HAN8002)
FS one
®
With FS One (HANS2000) you get more than photorealistic
fields, gorgeous skies and realistic-looking aircraft. You get
incredibly advanced aerodynamic modeling that simulates
every possible aspect of real-world flight.
The first Hangar Pack (HANS4010) will add even more
aircraft to FS One. This latest edition includes ten new planes
and helis from your favorite brands, including Hangar 9,
E-flite and Align. You'll be able to fly aircraft that are only
available on FS One such as the T-REX, Blade CX2, Blade CP
Pro, Hangar 9 P-51 and F-22 PTS. And as always, with the
Hangar Pack, you still get all the same great features that
you did with the original aircraft.
HANS2008
HANS4010
Important Information
Regarding Warranty Information
Please read our Warranty and Liability Limitations section on
Page 37 before building this product. If you as the purchaser
or user are not prepared to accept the liability associated
with the use of this Product, you are advised to return this
Product immediately in new and unused condition to the
place of purchase.
Hangar 9 Saratoga Assembly Manual
Advertisement
Table of Contents
