Landing Gear Installation - Hangar 9 Funtana 125 Assembly Manual


Step 27
Secure the tail wheel bracket to the fuselage using two 2mm
x 16mm self-tapping screws and a #1 Phillips screwdriver.
Hangar 9 Funtana 125 ARF Assembly Manual

Landing Gear Installation

Required Parts
Fuselage assembly Aluminum landing gear
Wheel axle (2) 4mm locknut (2)
4mm washer (5) 3mm blind nut (2)
Tail wheel, 1 / -inch (30mm)
1
4
Main wheel, 3-inch (90mm) (2)
3mm x 12mm hex head bolt (2)
4mm x 15mm hex head bolt (3)
Wheel collar with setscrew: 1/16-inch (2)
Wheel collar with setscrew: 4mm (2)
Tools and Adhesives
Light oil Flat file
Hex wrench: 1.5mm, 3mm Threadlock
Nut driver: 7mm Open end wrench: 10mm
Drill bit: 5/32-inch (4mm) Drill
Felt-tipped pen Ruler
Threadlock

Step 1
Locate the items necessary to attach the landing gear that
are included with your model.

Step 2
Slide one of the 1/16-inch wheel collars on the tail gear wire.
Use a 1.5mm hex wrench to tighten the setscrew and secure
the wheel collar to the wire.
Hint: Orient the wheel collar so the tapered end faces to
the wheel for less friction between the collar and wheel.

Step 3
Slide the tail wheel on the tail gear wire. Apply a small drop
of oil on the axle so the wheel can spin freely on the wire.
21