Hangar 9 Funtana 125 Assembly Manual page 11


Step 8
Secure the control horn to the elevator using three 2mm x
16mm self-tapping screws and a #1 Phillips screwdriver.

Step 9
Use a pin vise and a 1/16-inch (1.5mm) drill bit to drill a hole
in the center of each of the three hinge slots in the stabilizer
and elevator. This creates a tunnel for the CA to wick into,
making a better bond between the hinge and surrounding
wood.
Hangar 9 Funtana 125 ARF Assembly Manual

Step 10
Place a T-pin in the center of each of the three hinges that
will be used to hinge the elevator to the stabilizer. The
T-pins will center the hinge evenly in both the elevator and
stabilizer.

Step 11
Slide the hinges into the elevator.

Step 12
Slide the elevator in position against the stabilizer. Make sure
all three hinges go into the slots in the stabilizer.

Step 13
Position the elevator and stabilizer so their tips are aligned.
Remove the T-pins from the hinges.
11