Electric Motor Installation - Hangar 9 Funtana 125 Assembly Manual


Step 18
Attach the wheel pant using a 3mm x 12mm hex head bolt,
3mm washer and a 2.5mm hex wrench. Make sure to use
threadlock on the bolt so it won't vibrate loose in flight.

Step 19
Repeat Steps 14 through 18 to attach the remaining wheel
pant to the landing gear.
24

Electric Motor Installation

Required Parts
Fuselage assembly Plywood motor box
Motor with hardware Electronic speed control
4mm washer (8) Plywood battery tray
Hook and loop strap (5) Tie wrap (3)
Motor battery (2)
4mm x 15mm hex head bolts (8)
24-inch (610mm) servo extension
Tools and Adhesives
Hex wrench: 2.5mm, 3mm Soldering iron
Solder Ruler
30-minute epoxy Mixing cup
Mixing stick Paper towel
Rubbing alcohol Clear tape
Threadlock

Step 1
Locate the items necessary to install the electric motor
included with your model.

Step 2
Use a 2.5mm hex wrench to attach the propeller adapter to
the front of the motor. Make sure to use threadlock on the
screws so they don't vibrate loose.

Step 3
Use a 2.5mm hex wrench to attach the X-mount to the rear
of the motor. Again, use threadlock on the screws.
Hangar 9 Funtana 125 ARF Assembly Manual