Hinging The Elevators And Ailerons - Hangar 9 Funtana 125 Assembly Manual


Step 17
Place 2–3 drops of thin CA into each of the four holes to
harden the thread. This will keep the screws from vibrating
loose in flight.

Step 18
Prepare the throttle servo by installing the grommets and
brass eyelets as described in the servo instructions.
Hangar 9 Funtana 125 ARF Assembly Manual

Step 19
Secure the throttle servo in the fuselage using the screws
provided with the servo and a #1 Phillips screwdriver. Plug
the throttle servo into the receiver at this time.

Hinging the Elevators and Ailerons

Required Parts
Elevator (2) CA hinge (14)
Stabilizer (right and left) Wing panel (right and left)
Aileron (right and left) Control horn (4)
Control horn end (4)
2mm x 16mm self-tapping screw (12)
Tools and Adhesives
Ruler Felt-tipped pen
Phillips screwdriver: #1 Drill
Drill bit: 1/16-inch (1.5mm) Low-tack tape
Pin vise Thin CA
Hobby knife with #11 blade Hinge tape
T-pins
HINGING THE ELEvATORS

Step 1
Locate the items required to hinge the elevators and ailerons.
In addition, locate the hardware necessary to install the
control horns at this time as well.
9