Hangar 9 Funtana 125 Assembly Manual page 7


Step 4
Remove the servo. Place 2–3 drops of thin CA in each of the
holes to harden the surrounding wood. This harder surface
for the servo mounting screws makes them less likely to
vibrate loose.

Step 5
Secure an 18-inch (457mm) servo extension to the rudder
servo lead using string or dental floss. This will keep the
connection from disconnecting inside the fuselage.
Hint: Tie a small piece of string or place a piece of tape
on the end of the extension so you can differentiate the
rudder lead from the elevator leads later in this section
of the manual.
Hangar 9 Funtana 125 ARF Assembly Manual

Step 6
Mount the servo using the four screws that were included
with the servo. Tighten the screws using a #1 Phillips
screwdriver.

Step 7
Repeat Steps 3 through 6 to install the two elevator servos.
Make sure the output of the servos face to the rear of the
fuselage.

Step 8
Use a hobby knife with a #11 blade to remove the covering
from the side of the fuselage to expose the opening for the
receiver switch.

Step 9
Mount the switch to the side of the fuselage using the
hardware provided with the switch. Use a #1 Phillips
screwdriver to tighten the screws that secure the switch in
position.
7