Hangar 9 Funtana 125 Assembly Manual page 28


Step 6
Remove the engine from the mount and use a drill and a
5/32-inch (4mm) drill bit to drill the four holes for the engine
mounting bolts.
Hint: It is recommended to use a drill press to drill the
holes so they are straight in the mount.

Step 7
Use a drill and a 9/64-inch (3.5mm) drill bit to drill the hole
in the firewall for the throttle pushrod tube.
28

Step 8
Use medium sandpaper to sand a 1/4-inch (6mm) section
of the 16 / -inch (420mm) throttle pushrod tube at positions
1
2
that are 2-inch (51mm) and 6 / -inch (165mm) from one end
1
2
of the tube.

Step 9
Slide the pushrod tube in the firewall and guide it through
the fuel tank mount and alongside the receiver battery. The
amount of tube forward of the firewall should measure 1
inch (47mm). Use medium CA to glue the tube to the firewall
and the fuel tank mount.

Step 10
Use side cutters to trim the tube at the forward edge of the
throttle servo.
/ -
7
8
Hangar 9 Funtana 125 ARF Assembly Manual