Additional Required Adhesives; Fs One; Important Information Regarding Warranty Information; Section 1: Landing Gear Installation - Hangar 9 RV-8 Assembly Manual

Additional Required Adhesives

30-Minute Epoxy (HAN8002)
Canopy Glue (PAAPT56)
Medium CA (PAAPT02)
Thin CA (PAAPT08)

FS one

With FS One (HANS2008) you get more than photorealistic
®
fields, gorgeous skies and realistic-looking aircraft. You get
incredibly advanced aerodynamic modeling that simulates
every possible aspect of real-world flight.
The first Hangar Pack (HANS4010) will add even more
®
aircraft to FS One. This latest edition includes ten new planes
and helis from your favorite brands, including Hangar 9,
E-flite and Align. You'll be able to fly aircraft that are only
available on FS One such as the T-REX, Blade CX2, Blade CP
Pro, Hangar 9 P-51 and F-22 PTS. And as always, with the
Hangar Pack, you still get all the same great features that
you did with the original aircraft.
HANS2008
important information
Regarding Warranty information
Please read our Warranty and Liability Limitations section on
Page 40 before building this product. If you as the purchaser
or user are not prepared to accept the liability associated
with the use of this Product, you are advised to return this
Product immediately in new and unused condition to the
place of purchase.
Hangar 9 RV-8 Assembly Manual
Landing gear installation
Required Parts
Fuselage
Wheel pant (right and left)
Wheel collar, 4mm (4)
3mm washer (6)
Main landing gear right and left)
3mm x 10mm Phillips head screw (2)
3mm x 12mm socket head screw (6)
Tools and Adhesives
Drill bit: 1/8-inch (3mm)
Trim seal tool
Phillips screwdriver: #2
Box end or open end wrench: 10mm (2)
Hobby knife with #11 blade
Hex wrench or ball driver: 1.5mm, 2.5mm

Step 1
Carefully remove the canopy hatch from the fuselage by lifting
it up from the rear. It is secured by magnets at the rear and
dowels at the front. Slide the canopy rearward and set aside.
HANS4010
Section 1:
Wheel axle (2)
Wheel axle nut (2)
3mm x 3mm setscrew (4)
3mm blind nut (2)
Drill
Threadlock

Step 2
Use a hobby knife with a #11 blade to remove the covering
on the bottom of the fuselage to expose the mounts for the
main landing gear.
Hint: Use a trim seal tool to iron the covering around
the edges of the openings.
Hint: Seal the plywood by applying thin CA to
the exposed plywood after you have sealed the
covering down.

Step 3
Locate three 3mm x 12mm socket head screws and three
3mm washers. Slide a washer onto each of the screws.
5