Hangar 9 Funtana 125 Assembly Manual page 49


Step 6
Thread a ball end and clevis on a 3 /
3
4
pushrod. Thread both ends equally on the pushrod. The
overall length of the pushrod will be 4
assembled.

Step 7
Use a 4-40 x 1/2-inch and 4-40 locknut to secure the ball
end to the servo horn. Use a hole that is 1
from the center of the horn as shown. Use a 3/32-inch hex
wrench and 1/4-inch nut driver to tighten the hardware.
Note: We have also included 3mm x 12mm socket
head bolts and 3mm locknuts if you are not using JR or
Hangar 9 servo horns on your model. Use a 2.5mm hex
wrench and 5.5mm nut driver to tighten this hardware.
Hangar 9 Funtana 125 ARF Assembly Manual

Step 8
-inch (70mm) threaded Use the radio system to center the aileron servo. Use
the hardware included with the servo (and servo horn if
/ -inch (114mm) when applicable) to secure the servo horn to the aileron servo.
1
2
Make sure the horn is parallel to the aileron hinge line.

Step 9
Use a 2mm x 12mm machine screw, 2mm locknut and two
/ -inch (32mm) 2mm washers to secure the clevis to the aileron control
1
4
horn. Use a #1 Phillips screwdriver and a 4mm nut driver
to tighten the hardware. Don't over-tighten the hardware
causing the clevis to bind. It may be necessary to adjust the
length of the linkage slightly to center the aileron when the
aileron servo is centered.
2mm x 12mm machine screw
Washer

Step 10
Repeat Steps 2 through 9 to install the remaining aileron
servo and linkage.
Locknut
Washer
49