Hangar 9 Funtana 125 Assembly Manual page 20


Step 22
Gently pull on the rudder and fuselage to make sure each of
the hinges is secure. If not, reapply CA to the hinge that is
not secure.

Step 23
Flex the rudder through its range of motion a few dozen
times to break in the hinges.
20

Step 24
Use a felt-tipped pen to mark the locations for the two
screws that will secure the tail wheel bracket to the fuselage.

Step 25
Move the bracket out of the way and use a drill with a 1/16-
inch (1.5mm) drill bit to drill the two holes for the screws.

Step 26
Place 2–3 drops of thin CA into each hole to harden the
surrounding wood. This will keep the screws from pulling
out of the fuselage.
Hangar 9 Funtana 125 ARF Assembly Manual