Wing Installation - Hangar 9 Funtana 125 Assembly Manual

Wing Installation

Required Parts
Fuselage assembly Carbon wing tube
Wing fillet (2) Nylon wing bolt (2)
3mm x 12mm hex head bolt (6)
3mm washer (6)
Wing panel assembly (right and left)
Tools and Adhesives
Clear plastic or waxed paper Low-tack tape
30-minute epoxy Mixing cup
Mixing stick Epoxy brush
Rubbing alcohol Paper towel
Covering iron Hex wrench: 2.5mm
Hobby knife with #11 blade

Step 1
Locate the items necessary to attach the wing to the
fuselage.
50

Step 2
Use low-tack tape to keep the covering away from the area
where the wing fillet will be glued.

Step 3
Slide the carbon wing tube into one of the wing panels. Only
slide the tube in as far as it will easily slide. Forcing the tube
could possibly damage the wing.

Step 4
Use low-tack tape to tape a piece of plastic or waxed paper
to the fuselage directly behind the wing alignment dowel.
Make sure it doesn't cover the smaller hole where the wing
fillet plugs into the fuselage.

Step 5
Slide the wing panel and tube into position on the fuselage.
Make sure to guide the aileron servo lead through the slot in
the fuselage.
Hangar 9 Funtana 125 ARF Assembly Manual