Hangar 9 Funtana 125 Assembly Manual page 32


Step 8
Use a drill and a 9/64-inch (3.5mm) drill bit to drill the hole
in the firewall for the throttle pushrod tube.

Step 9
Use medium sandpaper to sand a 1/4-inch (6mm) section
of the 16 / -inch (420mm) throttle pushrod tube at positions
1
2
that are at one end of the tube and 4
one end of the tube.
32

Step 10
Slide the pushrod tube in the firewall and guide it through
the fuel tank mount and alongside the receiver battery. The
amount of tube forward of the firewall should measure
1/16-inch (1.5mm). Use medium CA to glue the tube to the
firewall and the fuel tank mount.
/ -inch (115mm) from
1
2

Step 11
Use side cutters to trim the tube at the forward edge of the
throttle servo.

Step 12
Connect the Z-bend in the 19 / -inch (492mm) throttle
3
8
pushrod to the outer hole of the carburetor arm as shown.
Hangar 9 Funtana 125 ARF Assembly Manual