Nikon SMZ25 Instruction Manual page 98

7
Attach the epi fluorescence attachment. (for the DIA + EPI-FL System)
Attach the P2-EFLM Motorized Epi Fluorescence Attachment or the P2-EFLI Epi Fluorescence Attachment to the
zooming body.
Both epi fluorescence attachments are attached to the zooming body in the same manner.
(1) Completely loosen the M4 set screw for the
illuminator at the top front of the zooming body using
a hex driver (nominal designation: 2).
(2) Align and fit the positioning groove at the far end of
the round dovetail at the bottom of the epi
fluorescence attachment with the positioning pin at
the far end of the round dovetail groove on top of the
zooming body, and then tighten the fixing screw.
 Connecting signal cables
Connect the signal cable that comes from the bottom of the epi fluorescence attachment to the connector "FL" on
the motorized focus unit or relay box. In case of the motorized unit, connect it inside the left cover of the intelligent
nosepiece. (See "[4] Connect the signal cables.")
 Attaching the HG fiber
Loosen the M4 set screw for the HG fiber on the top of the
HG fiber attachment hole on the rear side of the epi
fluorescence attachment using a hex driver (nominal
designation: 2).
Insert the emission side tip of the HG fiber to the
attachment hole until it reaches the limit and tighten the
fixing screw.
Firmly insert the source side connector to the HG fiber
attachment hole of the C-HGFI or C-HGFIE HG
Precentered Fiber Illuminator. See the instruction manual
for the light source for details.
 Attaching the fluorescent filter cube
Attach the filter cube to the turret in the epi fluorescence attachment. Up to four filter cubes can be attached.
Do not touch the surface of the filter with bare hands
Scratches or fingerprints on the filter surface will degrade microscope images. Handle the filter cube carefully.
Chapter 5
Assembling
Attaching the HG fiber by tightening the screw
84
Attaching the epi fluorescence attachment
Tightening the screw for epi fluorescence
attachment