Nikon SMZ25 Instruction Manual page 109

Directly placing the polarizer
When the LED diascopic illumination base is in use,
the polarizer can be removed from the polarizer
attachment and can be individually attached to the
diascopic illumination base. Fit it under the stage
plate of the diascopic illumination base. The stage
plate can be used as is.
3
Attach the P-SXY64 XY Stage.
Attach the P-SXY64 XY Stage to the P2-PB Plain Base,
P2-DBL LED Diascopic Illumination Base or P2-DBF Fiber
Diascopic Illumination Base.
(1) Remove the fastener for the stage. Loosen the four
M4 hexagon socket head bolts for the stage using a
hex wrench (nominal designation: 3).
(2) Loosen the M4 set screw for the stage plate on the
base using a hex driver (nominal designation: 2) to
detach the stage plate.
(3) Attach the P-SXY64 Stage using the four tap holes
that are located under the stage plate attachment
position.
Move the upper plate of the P-SXY64 to align the
installation holes on the lower plate with the tap
holes, insert the four M6 hexagon socket head bolts
and firmly tighten them using a hex wrench (nominal
designation: 5).
(4) Fit the glass plate supplied with the P-SXY64 XY
Stage on to the upper plate of the stage. The glass
plate has chamfered corners including one small
chamfered corner. Align the small chamfered corner
with the right rear side of the stage (as viewed from
the front) to fit the glass plate on the stage, and
tighten the glass plate fixing screw.
Y-stroke limit bolt
When attaching the P-SXY64 to the P-PS32 Plain Stand,
screw the Y-stroke limit bolt supplied with the P-SXY64
into the stage. Use a hex wrench (nominal designation:
2.5) when tightening the M3 hexagon socket head bolt.
Chapter 5
Assembling
Glass plate
fixing screw
Fastening
bolts (x4)
95
Y-stroke limit bolt
Fastener
Attaching the P-SXY64 Stage
by tightening the bolts
Small
chamfered
corner
Stage fixing
bolts (x4)