Nikon SMZ25 Instruction Manual page 106

2
Attach the focus mount.
Attach the P2-FMDN Focus Mount to the stand.
Fit the focus mount in the stand from the top of the support
and tighten the fixing knob on the rear side.
3
Attach the zooming body
Attach the SMZ18 Zooming Body to the focus mount.
(1) Completely loosen the two M5 hexagon socket head
bolts for the zooming body on the right side of the
zooming body (as viewed from the front) using a hex
driver (nominal designation: 4).
(2) Drop and fit the dovetail groove of the zooming body
onto the dovetail of the focus mount from the top.
(3) Remove the two rubber caps for the fixing bolt holes
on the right side of the focus mount (as viewed from
the front). Insert the hex driver (nominal designation:
4) into a hole and firmly tighten the two zooming
body fixing bolts. After tightening the bolts, put the
rubber caps back onto the bolt holes.
Chapter 5
Assembling
Attaching the focus mount by tightening the knob
92
Attaching the zooming body
by tightening the bolts