Bt Security Features; Bt Pin Code - Datalogic PowerScan PBT7100 Product Reference Manual

BT Security Features

These features enable/disable the BT system to require a configurable pin code to authen-
ticate/connect the BT devices, and encrypt the data.

BT Pin Code

This option specifies the 4-character pin code to be used for authentication of the BT
link.
code.
To set the pin code:
1. Determine the desired characters. For example, D254.
2.
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming
4. Scan the barcode: SELECT BT PIN CODE.
5. Scan the appropriate alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
ture.
This completes the procedure. See
Product Reference Guide
BT Security Mode on page 362
Convert the characters to hexidecimal using the
of this manual. In the case of the example, the hexidecimal equivalents would be:
D = 0x44, 2 = 0x32, 5 = 0x35, and 4 = 0x34
Mode.
representing the hexidecimal entries which was determined in the steps above. You will
hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
Mode.
Changing the pin code setting will unlink the devices. If the Automatic Con-
figuration Update is set to the default enabled setting, the devices must only
be relinked. If the Automatic Configuration Update is set to the disabled set-
ting, the Pin Code setting must also be updated in the Base Station using
NOTE
Aladdin. After the Base Station has been updated the devices must be
relinked.
must be enabled in order to require the pin
ASCII Chart
for some examples of how to set this fea-
Table 45
for some examples of how to set this feature.
Table 45
BT Security Features
on the inside back
cover
Appendix E, Keypad
359