Table of Contents
Advertisement
Checking Test Status
Use <stat> command to check the progress of the test. To check the detailed status for each
test, use <statv> command. This command shows the number of executed times and
progressing status of each time for each test.
The following is an example of screen using the commands.
TeDoLi> stat
Status
: Executing
Time
: 000:00:44
Total of tests : 15
Running
: 15
Pass
: 0
Failure
: 0
Warning
: 0
TeDoLi> statv 14
----------------------
BM/MB/PCI8/Port1(eth0)
----------------------
Test Count
: 74
Progress
: 49%
•
One of the following three statuses is displayed in "Status." This is the status of TeDoLi
itself.
Idle status
Executing status
Waiting for
Termination status
•
Elapsed time of the test being executed (elapsed time from entering <exec> command) is
displayed in "Time." The time is updated until all the tests are completed.
•
"Total of tests" shows the total number of tests. Test types are sorted as follows
depending on the executed test results.
Pass:
: Number of tests ended normally
Failure
: Number of tests ended with error
Warning : Number of tests ended with warning (# This is an information expanded
•
There are two procedures to specify the test with <statv> command.
Specifying "Test device number"
Specifying <all>
•
"Test Count" shows the number of executed test. This item shows "1" immediately after
starting the test.
•
"Progress" shows the degrees of progress of the test in the test round. This is not the
degree of progress for the entire rounds.
: Status before starting the test. Or the status after
the completion of test.
: Status that the test is being executed.
: Status that waiting for the completion of the test.
in the future and is not supported as of yet).
633
: Specifies the test device number in "Num" row.
: Specifies all the devices.
Operation and Maintenance
Advertisement
Table of Contents
Troubleshooting
