Table of Contents
Advertisement
9. Change "Initial Size" of "Paging file size for each drive" to a size larger than the
recommended value described in "Total paging file size for all drives", and change
"Maximum Size" to a size larger than "Initial Size"
IMPORTANT
● The paging file size described above is the recommended size for collecting
the debug information (dump file). For the boot volume, the paging file with
sufficient initial size for storing the dump file is required. If the size of the
paging file becomes insufficient, correct debug information may not be
collected because of the insufficient virtual memory. Make sure to set a
sufficient paging file size for the whole system.
●For more information on "Recommended" value, see "About the System
Partition Size", described earlier.
● When the memory is additionally installed, set the paging file again to match
the memory size.
10. Click "OK".
A message may be displayed to prompt the system reboot depending on the contents of
changed setting.
Follow the message and reboot the server.
This is the end of the procedure.
"Settings".
. Click
73
Advertisement
Table of Contents
Troubleshooting
