Table of Contents
Advertisement
13. Check test status.
Enter <stat> on the command line of the System Diagnostics screen to check the
executing status of the test.
The following is an example of screen using the command.
TeDoLi> stat
Status
Time
Total of tests : 15
Running
Pass
Failure
Warning
TeDoLi> statv 16
----------------------
BM/MB/PCI8/Port1(eth0)
----------------------
Test Count
Progress
·
Status: one of the following three statuses is displayed. This status is the status of TeDoLi
itself.
Idle status
Executing status
Waiting for Termination
status
·
Time: elapsed time of the test being executed (elapsed time from entering <exec> command)
is displayed. The time is updated until all the tests are completed.
·
Total of tests shows the total number of tests. Test types are sorted as follows depending on
the executed test results.
Pass:
: Number of tests ended normally
Failure
: Number of tests ended with error
Warning : Number of tests ended with warning (# This is an information expanded
·
Use <statv> command to check the detailed status (number of executed times and progress
of each time) for each test.
·
Test status can also be checked by using <list> on the test device list.
·
Use <term> command to terminate the current test forcibly.
,Refer to Command List for more details on each command.
: Executing
: 000:00:44
: 15
: 0
: 0
: 0
: 74
: 49%
: Status before starting the test. Or the status after
: Status that the test is being executed.
: Status that waiting for the completion of the test.
in the future and is not supported as of yet).
the completion of test.
623
Operation and Maintenance
Advertisement
Table of Contents
Troubleshooting
