Table of Contents
Advertisement
・ oemnecfirewall
・ Format
oemnecfirewall [<telnet|http> <on|off>]
・ Parameter
<telnet|http>: TELNET Protocol or HTTP Protocol
<on|off>: Enable or Disable
・ Description
This command sets the security settings regarding to tne network protocol of the
management firmware. It is possible to enable or disable the connection of TELNET or
HTTP. If no parameter is specified, the current setting is displayed.
・ Example
-> oemnecfirewall
-> oemnecfirewall telnet off
-> oemnecfirewall http on
HINT:
•Because the default settings for the TELNET and HTTP are
Enable, change it to Disable if there are any concerns on the
security.
IMPORTANT:
• The setting is applied immediately after executing this
command.
Even after the management firmware reset, the setting is valid.
539
Hardware
Advertisement
Table of Contents
Troubleshooting
