Appliance Preparation - Valor Legend G4 780IN Installation & Operating Instructions Manual

Gas Line Routing
Plan the routing of the gas line before proceeding.
Utilize the existing hole for the gas line of the factory-
built fireplace.
If the fireplace has no access hole, carefully drill an
access hole of 1.5 inch (38 mm) or less through the
lower sides or bottom of the firebox. The access hole
must be plugged with non-combustible insulation after
the gas supply line has been installed.
See Dimensions section for detailed location of gas
inlet. Also, take into consideration whether or not a fan
or shut-off valve will interfere when planning routing of
the gas line.
Existing Glass Doors and Wire Screens
Existing glass doors must be permanently removed
prior to installing the 780I insert.
Unpacking the appliance
Beware of sharp edges! Wear gloves!
1. Unpack the appliance.
2. Unpack any loose items from around the appliance
and check against the Pack Content list provided in
the documentation package.
3. Remove the window and set aside in a safe place to
avoid damage—see next page.
4. Verify that you have all the components required
for the installation, including:
- ceramic panels & fuel bed;
- trim;
- venting components and accessories;
- fan and electrical components for its
installation if used.
Existing Fireplace Preparation

Appliance Preparation

Combustible Mantels
Combustible mantel clearances must conform to those
required for the original solid-fuel fireplace into which
the 780I is being installed.
Attach Warning Conversion Plate to Existing
Fireplace (label supplied loose with 780I
heater)
Attach the "This fireplace has been converted..."
label to the existing fireplace using screws or other
mechanical means and store any removed parts in
back of the existing fireplace for future use.
11