Table of Contents
Advertisement
Installation
Unpack Appliance
Beware of sharp edges! Wear gloves!
1. Remove the cardboard wrapping and the wood pal-
let from the appliance and discard.
2. Unpack any loose items from around the appliance.
3. Remove the window and set aside in a safe place to
avoid damage—see page 28.
4. Verify that you have all the components re-
quired for the installation, including:
• approved cement board;
• liners and fuel bed (in separate cartons);
• trim kit with barrier screen;
• venting components and accessories;
• optional HeatShift system if used;
• electrical components if installing optional fan
or WiFi.
Fit Standoff s
1. The four top standoff s are supplied fl at on the fi re-
box top and fi xed at one end. Bend them as shown
and fi x the loose end to the top of the fi rebox.
Fold Lines
2. The four side stand-off s are supplied fl at. Bend
them and fi x them to the sides of the fi rebox as
indicated with the screws supplied (2 stand-off s per
side).
Outlet side standoff s
26
Other side standoff s
Appliance Preparation
Convert from Top to Rear Outlet (if required)
This unit is supplied with a top vent outlet which can
be fi eld-converted to a rear vent outlet.
Please note that the rear outlet requires the instal-
lation of the heat shield on top of the heater case as
indicated.
1. Remove the top outlet collar (6 screws).
Remove top outlet (6 screws)
2. Swivel the collar and install as a rear outlet (6 screws).
3. Reinstall the heat shield to the top of the appliance
case (3 screws).
Reinstall heat shield
to top of appliance
(3 screws)
Swivel the outlet so that it
is oriented towards the rear
and reinstall to heater
(6 screws)
Completed rear outlet with required heat shield
Advertisement
Table of Contents
